| Q: Where is the warranty label on HIPER PSU? |
| А: | The location of the warranty label is on the 1st screw above the main cable. In order to entitle for warranty service please make sure the warranty label is intact.
|
|
|
|
|
| Q: Where can I find the serial number of my PSU brackets? |
| А: | Both the packaging container and the PSU will have a serial number label.
Example of a serial number label:
|
|
|
|
|
| Q: I have a US version Type-R 580 PSU which is 115V. I would like to know if it will work in Europe where voltage is 220V. |
| А: | Our PSU should have a label at the back of the PSU near the I/O switch that states its acceptable voltage range. For US model it is 100-120V, for EU model it is 195-240V. Please do not use the incorrect model for your area in terms of voltage as it might damage the PSU. HIPER will not be responsible for any damages from misusage regarding using incorrect voltage model. |
|
|
|
|
| Q: I have a PSU and when a tester is applied to it there is no power coming accross the -5v rail. |
| А: | The -5V rail is removed according to the ATX v2.2 form factor and it's no longer needed. |
|
|
|
|
| Q: I bought a graphic card that requires PCI-E 8 pin however my PSU do not have PCI-E 8-pin connector, can I still use it? |
| А: | Please refer to the illustration. Although HIPER recommends to use PSU equips with proper 8-pin connector for these high-power graphic card for full performance, the PCI-E 6-pin connector can still be inserted into the 8-pin receptacle. The 8-pin receptacle is idiot-proof so that the 6-pin can be properly aligned when plugging in leaving 2 pins unoccupied. There is no need for an adaptor to convert 6-pin to 8 pin. The graphic card can detect whether a 8-pin or 6-pin connector is plugged and consumes power accordingly, however any graphics operation and actual display to a connected output device, whether VGA or otherwise, is not guaranteed and is implementation dependent. Please always refer to the graphic card manual for power requirement.
|
|
|
|
|
